The vibration box is a crucial component of the cement brick machine, and its proper maintenance is essential for the efficient operation and longevity of the equipment. Here are some key points to consider for the daily maintenance of the vibration box:
1. Oil Heating and Expansion
During operation, the high-speed rotation of the forced synchronous gears in the vibration box can cause the oil to heat up and atomize, leading to an increase in volume. When the machine cools down, the volume of the oil will contract sharply. To manage this, a breather valve is installed on the cover of the vibration box's vent hole. This valve allows the escape of gases that condense at the edge of the fuel's vent hole. Sometimes, these gases may leak from the combination gap due to the breather hole, but this is a normal phenomenon and not an oil leak.
2. Regular Oil Addition
It is recommended to regularly add a small amount of lubricating oil every 4-7 months to ensure the normal operation of the cement brick machine. The oil level should be controlled to maintain the proper height. You can also inject 20 to 30 centimeters of lubricant into the gears.
3. Replacement of Damaged Parts
Damaged parts should be replaced promptly. When replacing the bearings of the cement brick machine, it is important to move the eccentric shaft to avoid excessive vibration. Ensure that the breather valve remains unobstructed to prevent any blockages that could affect the machine's performance.
4. Belt Connection and Adjustment
The vibration box and the vibration motor are connected via a V-belt. Over time, the belt may loosen, which can affect the vibration effect and lead to a decrease in the density of the products produced by the cement brick machine. Regularly check and adjust the tension of the V-belt to ensure optimal performance.
5. Rare Failures and Timely Handling
While rare, failures such as bearing damage can occur in the vibration box. These issues need to be identified and replaced promptly to prevent motor failure. Monitor the vibration for any abnormalities or stoppages and address them immediately to avoid further damage.
Contact Us for More Information
For more details on our Road Curb Making Machine, or to discuss your specific requirements, please contact us at:
Fujian Unik Machinery Technology Co., Ltd.
Website: www.unikblockmachines.com
Address: No.19 Lin'an Road, Wuli Industry Zone, Jinjiang City, Fujian Province, China.
Phone: + (86) 18659803696
Email: sales@unikmachinery.com