The correct placing regulation for the brick-making machine is as follows:
Line out the center lines of the brick-making machine and the die according to all the available apparatus layout diagrams. Place the brick making machine in the correct position on the concrete pedestal in accordance with the brick-making center line and the die center line. (The concrete pedestal should be cast following the original installation diagram provided by the Jinjiang Unik Machine Co., Ltd, and overall maintenance is required.)
All the wires and tubes for electric and hydraulic purposes should be connected according to the drawings and joint marks contained in the installation instruction book.Check the preliminarily setting conditions of the hydraulic accumulator, as for specific requirements and regulations, check the instructions of the hydraulic part.The concrete band conveyor should be installed under the guidance of Unik service staff, in accordance with the diagrams provided by UNIK.Decide the die center line by following the diagram. Following the diagram, make correct dimensions and then place the hinge plate and the tubes behind the die center line.
Fix the bearing frame on concrete ground with four stone bolts. The molding principle machine should be installed according to the position of its base. Turn on the motor to let the rammer moving up and downs to check if the motion of the ram slider along the guiding column is smooth, without any resistance. And a complete installation of the ram and mold box is to be indicated by even gap between the ram and mold box with no collision during relative movements.